Hereof, are plywood clips code?
Bottom right: Installed nylon (plastic) H-clip and ready for next row of plywood sheathing panels. Because H-clips are not load rated, code approval is not required.
what is an H clip? H–Clips for Inspectors. by Nick Gromicko and Kenton Shepard. H–clips, also called panel-edge clips, are small steel devices that fit snugly between wood panels in order to provide them with edge support. They are often used with roof sheathing to keep it from feeling spongy or soft at its edges.
In respect to this, are clips required for roof sheathing?
For the most common roof sheathing in our area, which is 1/2” nominal (7/16” actual) sheathing over trusses or rafters at 24” on center, there is no requirement for H-clips. One or two H-clips will often allow a longer span between roof trusses/rafters.
How many plywood clips do I need?
For 16-inch centered framing, place the clip at the approximate middle-point between each perpendicular framing member. For 24-inch centered framing, position two clips equally spaced between rafters or joists approximately 8 inches apart.